Making a Tired Bathroom look New using a White Grout Colourant in Matlock Bath Derbyshire
I arranged to visit a property in the Derbyshire Dales village of Matlock Bath, to renovate the Ceramic bathroom tiles and grout. This is a beautiful area in the Peak District and consequently very popular with tourists.
I could see there was damage and missing grout to some areas of wall tiling, and this was resulting in damp staining to the hall ceiling below. The grout that was there was heavily stained even though it was only 2 years old. The client couldn’t understand why it had gotten so bad. I reassured him I could resolve the issue and get it looking like new again.
I cleaned down a small area of grout and applied a small amount of Tile Doctor Grout recolour in White. Instantly the client could see how good the finish would be. He agreed my quotation and booked me in the following week to do the work.
Cleaning and Repairing the Grout in a Ceramic Tiled Bathroom
I started by raking out any areas of loose or cracked grout and cleaning up the resultant debris. I then replaced all the missing grout with Mapei’s fast setting waterproof grout in White and left to dry.
Once dry I turned my attention to the rest of the grout which had discoloured from the use of soaps etc. To tackle this, I sprayed on a 3:1 dilution of Tile Doctor Duo Clean and left it to work its magic for approximately ten to fifteen minutes. This was followed by scrubbing the stained grout lines with a stiff grout brush and also wiping over the Ceramic tiles to ensure they were equally clean. The whole area was then rinsed down with water and dried with a cotton cloth.
Next was to spray the same areas with Tile Doctor Grout Colourant Pre-Treater and re-scrub the grout joints again. This prepares the grout for the colouring fluid to achieve a superior bond. I rinsed again with clean water to remove all traces and after another wipe down with a dry cloth I left the area to dry and went for a cup of tea.
After my cuppa I began to strip the stained silicone around the bath ensuring all traces of mould or grime build up was wiped away using Tile Doctor Duo Clean sprayed onto a cloth.
Sealing the Grout in a Tiled Bathroom
Once this was complete the grout areas were dry, so I started the application of a Tile Doctor Grout Colourant in White. This is done using a small brush and literally painted on to all the joints including the newly grouted areas to ensure a consistent finish. The excess is wiped off the tile as you go along and after two coats of colourant the grout was looking bright and sparkling clean again.
I finished the job by reapplying new sealant between the tiles and the bath using a mould resistant sanitary silicone in White.
As you can see, the bathroom was transformed by the work, in fact it looked like a new installation. Needless to say my client was delighted. Another benefit of the rough grout Colourant is it adds a smooth barrier over the grout making it very easy to clean.
